BrewPiLess

Start Date:
°C Condition Days SG Stable Start Time
19
Ramp
71.01
Set Beer Temp:°C
Set Fridge temp:°C
Turning temperature control off.
Cooling Target°C
Heating Target°C
hysteresisMode (predictive heater)

Uses heatTargetH/L and coolTargetH/L from Advanced Settings. Predictive On: cycle 1 measures thermostat on-time to beerSet+heatTargetH; later cycles heat for the learned seconds; if the beer peak is low, a same-cycle top-up runs after the peak falls (slow filter, 3 s). Over/under next-cycle correction uses full slope-based seconds; changes under 10 s are ignored (deadband). Heater always cuts if beer reaches the upper target. Cooler is unchanged.

CAPPING CONTROL
Spunding when gravity is less than
to psi
Glycol Temperature Control
Target Temperature
°C
Triggering Temperauture
°C
Minimum Cooling Time
Seconds
Miminum Idle Time
Seconds
Humidity Control
Mode
Target Relative Humidity
%